6
Installing the Faceplate to the Case
Screw the faceplate to the bottom half of the case with the included screws. Do not over
tighten the screws, the faceplate may crack or the screw holes in the bottom half of the box may strip
out.
Wiring Your Driver
You should now have a completed dimming box. Wire it as follows:
•
Wire the DIM + output from your dimming box to DIM + (blue) on your driver(s).
•
Wire the DIM – output from your dimming box to DIM – (white) on your driver (s).
The output wires from each potentiometer go to one or a set of drivers for dimming. Never
combine output wires from one potentiometer with the other!
The outputs for each
potentiometer must always be on separate circuits.
Using Your Dimmer
To use your dimmer, plug the included AC adapter into the DC jack on the box (and into the
wall). Rotate the knobs clockwise to increase output voltage (brightness) and counter-clockwise to
decrease voltage. This assumes your ELN-60-48D drivers have been pre-configured and set up properly
for your application. Please review our document entitled “Using Your Dimmable Driver” in detail
before starting use of the ELN-60-48D drivers.
To DIM+ on Driver
To DIM+ on Driver
To DIM — on Driver
To DIM — on Driver
