5
Completed Wiring
Below is a photo of completed wiring. Using the photo below and the above wiring diagram, please wire
your kit the same.
Soldering notes:
•
You will need to run a wire from the – terminal as well as a wire from the middle terminal of
each potentiometer out to your driver(s) as labeled in the photo below
•
Be sure to solder as close to the base of the terminals as possible on the DC jack. Soldering too
far from the base may make the DC jack too tall to fit into the case.
Installing Knobs to Potentiometers
Before screwing the faceplate to the bottom half of the dimmer case, the knobs should be
installed on to the potentiometers. The knobs simply push on to the potentiometer shafts. Rotate the
potentiometers counter-clockwise as far as they will rotate and then gently push the knobs on to the
potentiometer shafts at the desired angle. It is best to do this by putting pressure on the back of the
potentiometer
to DIM + on driver
to DIM - on driver
to DIM + on driver
to DIM - on driver
