3
Tinning DC Jack
Next, tin the DC jack terminals in the same manner as the potentiometer terminals.
Installing Potentiometers to Faceplate
Next, we will install the potentiometers to the faceplate:
1.
Insert the potentiometers such that the alignment tab on the potentiometer inserts into
the alignment hole in the faceplate (see photos below). The potentiometer should sit
flush, not at an angle in relation to the faceplate.
2.
Put the included washer over the potentiometer shaft followed by the locking nut.
3.
Screw the locking nut down and tighten until snug, but not too tight. We don’t want to
crack the faceplate by over-tightening.
Not Tinned
Tinned
