Ransomes G-Plex II, Руководство по безопасности и эксплуатации

Страница: 11 / 122

GB-9
RANSOMES G PLEX II Series :WD
SAFETY AND OPERATORS MANUAL
GB
WARNING
· DO NOT
attempt to force the direction
control pedal to the neutral (stop) position
or to change directions before coming to a
complete stop. Abrupt stops or changes in
direction may cause serious injury.
1
2
Figure 13
1. Direction/Speed Pedal
2. Brake Pedal
NOTICE
• To reduce fatigue during normal forward
operation, the operator’s heel should rest
on the floorboard next to the pedal
(not on
the lower part of the pedal).
The
Mow/Lift Pedal
(See Fig. 14) lowers and raises
the cutting heads.
To Lower the Heads:
Depress the front of the
pedal into the lowered head position. If
reel enable switch is on, reel rotation starts
when the heads are lowered.
To Raise the Heads:
Depress the back of the pedal
into the raised head position. Reel rotation
stops when the heads are raised.
1
Figure 14
1. Mow/Lift Pedal
ADJUSTMENTS
WARNING
•
Adjustment procedures must be performed as
specified by properly trained service
personnel
ONLY
. If assistance is needed,
contact your local Ransomes Textron Dealer.
•
To avoid the possibility of serious injury,
switch the reel enable switch to the off
position, lower the heads, stop the engine,
remove the key and set the parking brake
BEFORE
making any adjustment.
•
The rear swing out arm is to allow you easy
access to the rear cutting head. The cutting
heads
MUST BE
in the raised position.
DO
NOT
swing the arm out with the cutting
heads in the lowered position.
• NEVER
rotate the cutting reel by pushing it
with your hands or fingers. Fingers can
become caught between the reel and the
frame resulting in serious injury. Use a ratchet
with a
9
/
16”
socket on the end of the cutting
head shaft to rotate the reel during
adjustment and testing (See Fig. 15).
1
Cutting Head Shown
with
Rear Rotary Brush
Accessory mounted
Figure 15
1. Rotate Cutting Reel with this Screw Head
BEDKNIFE ADJUSTMENT
For this adjustment, the backlap valve control lever
must be in the center
“neutral”
position so that the
reels can be rotated manually.
WARNING
· To avoid the possibility of serious injury,
NEVER attempt any cutting head
adjustment while the engine is running.
Any adjustment to the clearance between the reel
blades and the bedknife should be done at the
leading end of the reel first (the end at which
each individual blade first crosses the
bedknife). Then at the opposite end of the
reel.
1. Loosen the
lower
adjustment screws at each
end by turning them approximately 1/4 turn
counterclockwise (See Figure 16).
2. While rotating the reel backwards, turn the
upper
adjustment screws (leading end first)
until there is approximately .025mm
clearance. After adjusting both ends, recheck
the leading end.