Ranger Wheel Guardian RV1, Инструкция по установке и эксплуатации

Страница: 17 / 80

RV1 Wheel Guardian™ Tire Changer
17
P/N 5900089 — Rev. A — March 2019
Connecting to a Power Source
The Tire Changer has to be connected to a 208-230 VAC power source.
A Power Cord with
no Plug
is provided with the unit. You need to have a licensed, certified Electrician
wire the open end of the Power Cord to an appropriate 208-230 VAC NEMA 30 Amp Plug.
Refer to
Plug Wiring Information for additional wiring information.
⚠
WARNING
All electrical work must be done by a licensed, certified Electrician .
Additional electrical information:
•
Make sure wiring is done in accordance with National Electric Code (NED) and local codes and
standards covering electrical apparatus and wiring.
• Operation with no Ground can damage electronics and could create a shock hazard. You must
ground the unit
.
• Damage caused by improper electrical installation (not grounding the unit, for example) voids the
warranty.
• The Tire Changer uses pneumatic and electrical energy; if your organization has Lockout/Tagout
policies, make sure to implement them after connecting to the power source.
• Make sure that adequate wire sizes are used, service is of adequate amp rating, the supply line
has the same electrical characteristics (voltage, cycles, and phase) as the motor, and that no other
equipment is operated from the same line.
• Electrical codes may require “hard-wiring” when the machine is anchored to the floor. Consult a
licensed Electrician regarding the applicable codes for your location.
⚠
WARNING
Disconnect power before performing any maintenance
. Make sure the
unit cannot be reenergized until you are done with maintenance; secure the plug so
that it cannot be accidentally plugged back in. If your organization has
Lockout/Tagout policies, make sure to implement them. This equipment has
internal arcing or sparking parts that should not be exposed to flammable vapors.
The unit must not be located in a recessed area or below floor level.