Your Boat’s Finish
3. Wash area with a solvent such as acetone and allow to dry.
4. Using Ranger touch-up gel-coat or putty only, thoroughly mix 1%
catalyst (MEKP) with desired amount of gel-coat or putty.
5. With a putty knife, trowel catalyzed gel-coat in desired area, leaving it
slightly higher than the original surface to allow for shrinkage.
6. When patch has dried, remove masking tape and carefully sand back
to the original shape using #600 grit WET sandpaper. Then buff with a
light duty buffing compound.
NOTE: Area may have to be filled more than once due to shrinkage.
NOTE: Due to different dye lots the color may vary somewhat. However,
we take all the steps to keep our color consistent.
31
Gel-coat will not cure by itself. You must use
a catalyst.
NOTICE
▲
!
Do not hold buffer in one area long enough
to burn gel-coat.
NOTICE
▲
!
These materials are very flammable. Do
not smoke or use electric equipment
while using them. Improper handling could result in an explosion
resulting in injury or death.
WARNING
▲
!
Содержание 191 CAYMAN
