Ranger Products R715, Инструкция по установке и эксплуатации

Страница: 30 / 36

Disconnect air supply to machine.
Add oil to the lubricator if the fluid level is below the
middle of the oil reservoir. Unscrew the Oil Reservoir, add
SAE 10W non-detergent oil or an air tool oil if necessary.
NOTE:
This adjustment will require two persons to perform.
1. With the Air source connected, depress the Bead
Breaker Pedal to operate the Bead Breaker.
2. Observe the site glass and adjust the oil flow of the
oiler by turning the Oiler Adjustment Knob so that 2-3
drops of oil drip through the site glass for each operation
of the Bead Breaker Pedal. (See Fig 17.6)
(Either reservoir may be removed for cleaning by turning
the reservoir counter-clockwise and pulling down.)
3. Reconnect the air supply when service/adjustments are
complete.
Turntable Drive Belt Inspection / Adjustment.
DANGER! The motor on this machine contains high
voltage. Disconnect power at the receptacle before
performing any electrical repairs. Secure plug so that it
cannot be accidentally plugged in during service.
1. Remove the Side Panel. (See Fig. 17.12)
2. Loosen the four Motor mounting / adjusting bolts and
nuts. (See Fig. 17.13)
3. Inspect the Drive Belt for cracking and wear and
replace as necessary. Adjust the Belt deflection to
3/8” - 1/2”. (See Fig. 17.14)
30
Fig. 17.5
Fig. 17.6
Fig. 17.12
Fig. 17.13
Fig. 17.14