Ranger Products R715, Инструкция по установке и эксплуатации

Страница: 15 / 36

15
1. Check the voltage, phase and proper amperage requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician only.
2. Overheating, short circuits and fire damage will result from inadequate wiring. Wiring must be installed in accordance
with National Electric Code and local codes and standards covering electrical apparatus and wiring.
3. Be certain that adequate wire sizes are used, and that:
Service is of adequate amp rating.
The supply line has the same electrical characteristics (voltage, cycles and phase) as the motor.
The line wire is the proper size and that no other equipment is operated from the same line.
Check the voltage, phase and proper amperage requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician only.
IMPORTANT NOTE:
YOUR MACHINE HAS A DUAL VOLTAGE MOTOR and can be run on either 110 or 220 volts.
STANDARD WIRING IS 110 VOLTS.
See below before connecting 220 volts to your machine or serious damage to the motor/electronics will result. Have a
licensed electrical technician perform any necessary changes to the power source and power cord before plugging in
the unit. The electrical source must have a solid connection between ground and building ground.
Confirm voltage selector switch is positioned correctly before connecting power to your machine or serious damage to the
motor/electronics will result. (See Fig. 10.2)
Refer to Page 7 Item # 19 for location of Voltage Selector Switch
WIRING INSTRUCTIONS
Fig. 10.2