Wheel Clamp Adjustments
9. Place the Wheel Protections pads on the Wheel Clamps
if desired when clamping from the outside. (See Fig. 11.5)
10. Place tire/wheel assembly on Table Top with mounting
side up. (See Fig. 11.6)
11. Use the Wheel Clamp Foot Pedal to move the Clamps
inward or outward. (See Fig. 11.7 & 11.8)
12. Apply tire manufacturer’s approved rubber lubricant
liberally to entire circumference of both upper and lower
beads after loosening bead and placing on table top.
(See Fig. 11.9)
13. After the wheel is secured to the Turntable, pull the
Overhead Swing Arm into position, use the Large
adjusting Knob to position the Mount/Demount Head
(Duckhead) directly over the edge of the rim.
(See Fig. 11.10)
18
NOTE:
Clamp steel wheels from the inside (clamps
push outward against wheel). Clamp mag and
custom wheels from the outside (Clamps push
inward against the outside rim edge). Refer to the
Performance Tires and Wheels section.
Fig. 11.5
Fig. 11.6
Fig. 11.7
Fig. 11.8
Fig. 11.9
Fig. 11.10
WARNING!
THE RIM AND BEAD MUST BE LIBERALLY
LUBRICATED. FAILURE TO USE AN ADEQUATE
LUBRICANT CAN LEAD TO THE BEAD BINDING ON
THE RIM AND LEAD TO DAMAGE TO THE MOTOR
AND OR VOID THE WARRANTY.
Содержание R715
Страница 32: ...32...
Страница 33: ...33 RECORD ALL MAINTENANCE NOTES AND SERVICE HISTORY HERE...
Страница 34: ...34 5 7 5 1 5...