Ranger Products R23, Инструкция по установке и эксплуатации

Страница: 8 / 48

9
LIFTING
Handling of the machine must be performed only with an
appropriate lifting device such as a forklift or pallet jack.
Only personnel who are experienced and qualified
on material handling procedures should handle any
transportation or moving of machine.
Uncrating Instructions
Carefully remove the crating and packing materials and all
skid and pallet fasteners.
Be careful when cutting steel banding material as items
may become loose and fall causing personal harm or
injury. Always wear gloves when uncrating the machine to
prevent scratches, abrasions, or cuts due to the contact
with packing materials. Remember to report any shipping
damage to the carrier and make a notation on the delivery
receipt .
INSTALLATION
Disconnect tag and lock out power source before
attempting to install, service, relocate or perform any
maintenance.
Do not lift or move unit without appropriately rated
equipment. Be sure the unit is securely attached to any
lifting device used.
Never use the wood shipping skid for mounting the unit.
Select a location using the drawings on pages below. The
area should provide the operator with enough space to use
the equipment in a safe manner. The area selected should
be well lit, easy to clean and should be away from oil,
grease, brake lathe chips, etc. Avoid areas where
bystanders and customers may be present.
Operating Area needed is approximately:
90” x 80” x 86”
These measurements are the tire changer’s working range.
Persons other than specially trained and authorized
operators are expressly forbidden to enter this area.
Choose a safe location that is in compliance with
current work place safety regulations.
Failure to properly install the machine can lead to
improper and unsafe operation.
Fig. 1
Proper unit installation is necessary for safe use
and efficient operation. Proper installation also
helps protect the unit from damage and makes
service easier. Always keep this manual with unit.