Ranger Products R23, Инструкция по установке и эксплуатации

Страница: 22 / 48

22
MONTHLY
The vertical and horizontal slides and the helper slides
should be cleaned with a vaporizing solvent and then
lubricated with chassis grease once a month.
(See Fig. 1-2)
Check adjustment of the mount/demount head
monthly.
Check function of the inflation hose pressure
limiter/regulator monthly. Always secure/stow the cover if
adjustments are made.
The pressure regulator should
never be adjusted to exceed 60 PSI.
The table top, clamps, steel mount/demount head, and
other working surfaces should be cleaned with a vaporizing
solvent every month.
On a daily basis, inspect the unit and check to be
certain that all systems are operating normally. Follow
detailed inspection and testing procedures as specified for
various components at regular intervals.
Replace any damaged or missing safety decal’s. They
are available from the factory.
Mount/Demount Tool Head Adjustment
To adjust tool head lift, adjust locking nut up or down until
lift clearance is 1/8” to 3/16”. Recheck clearance before
replacing cover. (See Fig. 3)
To Adjust Tool Head Setback
Remove top cover, loosen jam nut and adjust screw until
setback clearance is 1/16” to 3/16”. Tighten jam nut and
check. (See Fig. 4)
Mount/Demount Head Cleaning
Clean dirt and debris from the mount/demount tool roller
with small screw driver or pick. (See Fig. 5)
Water Separator/Lubricator Maintenance
Check oil and water levels regularly, and perform these
maintenance items weekly:
Disconnect air supply to machine. (See Fig. 6)
Observe the sight glass on the water separator/filter
unit. If water is observed, drain by pressing upwards on the
drain plug at the bottom of the reservoir. (See Fig. 7)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7