Ranger Products R23, Инструкция по установке и эксплуатации

Страница: 13 / 48

13
15. Push the locking valve button to lock the slides into
place. As the slides are locked, the mount/demount head
will move upward approximately 1/8 inch and backward
1/8 inch from the rim edge. The mount/demount head roller
should not be in contact with the rim edge. (See Fig. 1)
16. Move the left hand top helper into position opposite the
mount/demount head positioning the edge of the helper just
outside the rim edge. (See Fig. 2-3)
17. Press down on the left hand control valve. (See Fig. 4)
18. Power the left top helper down to force the tire bead into
the drop the center of the wheel. (See Fig. 5-6)
19. Insert the smooth curved end of tool bar over the right
end knob of the mount/demount head and below the top
bead of the tire. (See Fig. 7 & 8)
20. Push the tool bar down toward the wheel to lift the tire
bead up and over the right -side knob portion of the demount
head. Hold the tool bar in this position. (See Fig. 9-10)
NOTE
This clearance will be maintained as long as the
slide locking valve remains locked. The operator
may tilt the tower back out of the way and back into
place again without needing to reposition the head
when changing a like set of wheels. The tool clear-
ance may change with machine use and should be
inspected often. Failure to maintain proper clear-
ance may result in damage to the wheel rim or tire.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9