EcoPro300
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
31.) Re-install 10mm bolt & nut to hold cage in place, do not tighten as the
safety cage needs to swivel.
32.) Re-install cotter pin in end of safety cage round bar
33.) Remove nut from chainsaw tensioner and put plastic tubing in place, re-
tighten the nut to hold the plastic tubing and seal, do not over tighten.
34.) Run the tubing through the safety cage, make sure cage can open and
close freely, push the end of the tubing into the tank fitting.
35.) Put toolbox into place and tighten 22 – 13mm nuts and bolts
36.) Remove the 16mm bolt & 17mm nut from the end of the hitch
drawbar.
37.) Place drawbar in receiver tube by the engine, re-install 16mm bolt and
17mm nut, tighten.
38.) Tig
hten both 18mm bolts on the receiver tube, tighten the lock nuts.
