EcoPro300
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
14.) Re-install axle nut and tighten until whell is hard to turn, then
back the nut off until the whell turns freely.
15.) Line up holes and install cotter pin
16.) Install hub cap and tap lightly to get it into place
17.) Torque wheel nuts to 70-80 ft/lbs
18.) Centre fender over tire and tighten the 13mm nuts and bolts
19.) Install tripod leg in front mount and lower processor to the ground
20.) If this unit was supplied with both a spring and a gas cylinder for the
saw return it is up to the assembler which method to use
- If you use the spring continue to 20a and skip 20b
- if using the gas cylinder skip 20a and continue at 20b
20a)- if you decide to use the spring, a 7mm socket on an extension works
to lock the spring in its tab, the 7mm socket fits over the end of the
spring and allows you to safely apply downward pressure to put the spring in
place under the tab
