EcoPro300
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Ram Hood Adjustment
The 2 brackets on the ram hood must be checked for adjustment to make
sure the ram does not extend to far and that when it returns it does not
have a hard hitting stop.
1
st
) The rear bracket hits the manual ram bar as the rams goes out, it
needs to be adjusted so that it hits the return bar before the ram is fully
extended. This is set from the factory but should always be checked.
2
nd
) The front bracket hits the post on the manual return arm as the ram
returns home, this must hit the post before the ram hits its internal stops,
softening the stop.
This should be adjusted so that the ram hood does not stick out into the
splitting valley when it is in the home position, it should not be sunk into the
housing, it should sit almost flush will the front wall.
Again – this is set at the factory – do not adjust unless there is a problem.
Optional: If the customer is only cutting and splitting shorter lengths, the
bar can be reversed to shorten the stroke and reduce the cycle time
