EcoPro300
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
6.) Insert axle into the square tube at the rear of the processor, centre
the axle in the housing and the tighten the bolts, Make sure the holes in
the axles are facing up, when the bolts are tightened then tighten the nuts
7.) Once the bolts are tight, tighten the nuts to lock the bolts in place
8.) Mount the fenders on the axle, snug the bolts but do not tighten, holes
in the fenders go to the rear
9.) Gently remove dust seals from the rear of the hubs
10.) Grease all 4 bearing cones with wheel bearing grease
11.) Re-install bearings and dust seals
12.) Remove the nuts from the axle shaft
13.) Install wheel and hub onto the axle and install the outside bearing
cones.
