R&S VTE, Начало работы

Страница: 39 / 52

Operating the R&S VTE in a LAN
R&S
®
VTE
39 Getting Started 2116.1270.02 ─ 07
2. Connect the computer and the R&S VTE with a standard RJ.45 cross-over
cable (LAN cable).
After approx. 16
seconds, the connection is established.
3. To address the R&S VTE, use the computer name.
Further information:
●
" Querying the computer name using the firmware" on page 40
6.2.2 Other Operating Systems
If Windows 7 is not installed on the computer, you need to assign IP addresses.
1. Assign an IP address to the R&S VTE and the computer.
The IP addresses 192.168.xxx.yyy are available for use here. xxx and yyy can
assume values of 1 to 255 . The value for the subnet mask is 255.255.255.0 .
2. Connect the R&S VTE and the computer with a standard RJ.45 cross-over
cable (LAN cable).
3. To address the R&S VTE, use the assigned IP address.
6.3 Zero Configuration Networking
The R&S mDNS service is installed with the firmware. Using this service, you can
connect to a network automatically. You do not need to set up services, such as
dynamic host configuration protocol (DHCP) and domain name system (DNS), or
configure the network settings manually as described in
Chapter 6.4, "Configuring
the Network Card" , on page 39.
6.4 Configuring the Network Card
Under Windows 7, network card drivers do not need to be installed separately. If
the R&S VTE is connected to the LAN, Windows 7 automatically detects the net-
work connection and activates the required drivers.
Configuring the Network Card