R&S VTE, Начало работы

Страница: 32 / 52

Instrument Tour
R&S
®
VTE
32 Getting Started 2116.1270.02 ─ 07
Observe the safety instructions in "Connecting to power" on page 9.
The IEC 320/EN 60320 AC power supply connector and the AC power switch are
combined (type C14). For the ratings of the power supply, refer to the data sheet.
A fuse holder is integrated.
The AC power switch is located above the AC power supply connector.
Switch positions:
●
[I]: Depending on the setting of the standby key on the front panel, the
R&S
VTE is either in standby mode or in operation.
●
[O]: The entire instrument is disconnected from the AC power supply.
Further information:
●
Chapter 4.5, "Connecting to Power" , on page 21
●
Chapter 4.7, "Switching On or Off" , on page 23
●
For changing the fuses, see the user manual.
5.2.2 TRIGGER Input
See (1) in Figure 5-2 .
BNC connector. Input for external triggering.
5.2.3 MARKER Output
See (2) in Figure 5-2 .
BNC connector. Output of the internal marker signal.
See the user manual or the help system.
5.2.4 EXT REF IN
See (4) in Figure 5-2 .
BNC connector. Input for the external reference frequency.
See the user manual or the help system.
Rear Panel