R&S VTE, Начало работы

Страница: 21 / 52

Preparing for Use
R&S
®
VTE
21 Getting Started 2116.1270.02 ─ 07
Signal input and output levels
Information on signal levels is provided in the data sheet. Keep the signal levels
within the specified ranges to avoid damage to the product and connected devi-
ces.
4.5 Connecting to Power
For safety information, see "Connecting to power" on page 9.
The R&S VTE is powered by alternating current.
1. Plug the AC power cable into the AC power connector on the rear panel of the
product. Only use the AC power cable delivered with the product.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
Further information:
●
Chapter 5.2.1, "AC Power Supply Connector and Switch" , on page 31
4.6 Connecting External USB Devices
Using the USB interfaces, you can directly connect USB devices to the R&S VTE.
This number can be increased as necessary by using USB hubs.
Due to the large number of available USB devices, there is almost no limit to the
possible expansions. In the following, USB devices that can be useful are listed.
●
Keyboard for entering comments, file names, etc. or for easy access to Win-
dows
7 settings. See Chapter 4.6.1, "External Keyboard" , on page 22.
●
Mouse if you prefer this way of operation over a touchscreen. See Chap-
ter 4.6.2, "Mouse" , on page 23.
●
Memory stick for easy transfer of data to/from a computer (e.g. firmware
updates). See
Chapter 4.6.3, "Memory Stick" , on page 23.
●
External drives for easy installation of firmware applications. See Chap-
ter 4.6.4, "External Drive" , on page 23.
Connecting External USB Devices