R&S SMB100B, Начало работы

Страница: 25 / 61

Preparing for Use
R&S
®
SMB100B
25 Getting Started 1422.1045.02 ─ 03
To switch on the R&S SMB100B
The R&S SMB100B is off but connected to power. See Chapter 4.6, "Connecting
to Power" , on page 19.
1. Set the switch on the power supply to position [I].
The switch is located on the rear panel .
The LED of the [On/Standby] key is orange.
2. Wait until the oven-controlled oscillator (OCXO) warms up. For the warm-up
time, see data sheet.
3. Press the [On/Standby] key.
Key and LED are located on the front panel .
The LED changes to green. The R&S SMB100B boots.
When starting for the first time, the R&S SMB100B starts with the default set-
tings. When restarting the instrument, the settings depend on the instrument
configuration before shut-down.
See the chapter "Saving and Recalling Instrument Settings" in the user man-
ual.
When the instrument is switched on, it automatically monitors main functions. You
can query erroneous functions. In addition to automatic monitoring, you can per-
form maintenance tasks.
See:
●
Chapter "Querying Error Messages" in the user manual.
●
Chapter "Performing Maintenance Tasks" in the user manual.
To shut down the R&S SMB100B
The R&S SMB100B is in the ready state.
► Press the On/Standby key.
The operating system shuts down. The LED changes to orange.
In the standby state, the power switch circuits and the OCXO are active. To deac-
tivate them, disconnect the instrument from the power supply.
Switching On or Off