DISASSEMBLY
DISASSEMBLY
14
TOOL DISASSEMBLY
1.
After being sure that the tool is
not loaded and having removed
the spall guard, unscrew the thread
protector and plastic heat shield. It
will be necessary to hold the
muzzle bushing shroud to keep it
from turning while removing the
heat shield.
2.
Slide the heat shield off of the
muzzle bushing shroud and then
unscrew the muzzle bushing
assembly from the barrel assembly.
It may be necessary to use a
wrench to loosen the muzzle
bushing from the barrel.
3.
Slide the piston out of the barrel. If
it is too tight, you may use a long
fastener or brass rod to push the
piston out by inserting the fastener
or pin into the barrel through the
chamber.
4.
With the tip of a fastener or a flat
blade screwdriver, lift the lip of the
barrel retaining spring and rotate it
away from the pawl. Do not rotate it
past the barrel retaining ball unless
the ball is to be replaced. Turn the
tool over and catch the pawl as it
falls out of the receiver assembly.
Note the alignment of the pawl slot
in the barrel with the rectangular
opening for the pawl.
5. Slide the barrel assembly out of the
receiver, again noting the position of
the pawl slot in the upper portion of
the barrel and the open slot in the
lower portion of the barrel.
REMOVE THREAD PROTECTOR
AND HEAT SHIELD
UNSCREW AND REMOVE MUZZLE
BUSHING ASSEMBLY
SLIDE BARREL RETAINING
SPRING AWAY FROM PAWL
REMOVE PAWL AND BARREL
FROM RECEIVER
SLIDE PISTON OUT OF BARREL
Содержание MD380
Страница 12: ...PARTS SCHEMATIC PARTS SCHEMATIC 12...
