RAMSET MD380, Инструкция по безопасности и эксплуатации оператора

Страница: 7 / 16

FASTENERS / LOADS
FASTENERS / LOADS
7
Your Ramset MD380 tool uses only the Ramset fasteners and loads shown
below or listed for the tool in the Product Catalog .
DANGER
3/8” HEAD DIAMETER DRIVE PINS
Never use any other types of fasteners or loads in the MD380 tool.
Use of other types of fasteners or loads may cause unintentional load discharge,
damage the tool, cause poor fastening performance, or create a risk of serious
injury to the operator or bystanders.
FASTENERS
LOADS
POWER CATALOG LOAD CASE
LEVEL NUMBER COLOR COLOR
4 4RL27 Yellow Brass
5 5RL27 Red Brass
6 6RL27 Purple Brass
The power level of the loads is
indicated by the number marked on
each box, the color of the box and
the color on the tip of each load. As
the number increases, the power
level also increases.
Always perform the center punch
test described on page 3 to test the
base material.
Always make a test fastening using
the #4, Yellow, power level first. If
more power is required to set the
fastener, use the next higher power
level until the power level necessary
to drive the fastener is reached.
Ramset .27cal. RL loads are specially made for use in the MD380 Tool.
RAMSET RL LOAD
3/8” - 16 THREADED STUDS
.180 Shank Diameter in Shank
Lengths from 3/4” to 3”
.205 Shank Diameter in Shank
lengths from 5/8” to 1 1/4” and
1” Thread Length
SEE PRODUCT CATALOG FOR SPECIFIC LENGTHS