TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
TOOL OPERATION
Daily Function Test
Always check the tool first to make
sure that it does not contain a load
or fastener.
Test the tool several times
by depressing the muzzle bushing fully
on a hard surface and pulling the trigger.
You should hear an audible click as the
firing pin releases. Let up on the tool and
check to be sure that the barrel has
opened to the semi-closed position.
PERFORM FUNCTION TEST
WITH EMPTY, UNLOADED TOOL
SLIDE THE BARREL
FORWARD
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL
WITH THE POINT OUT
OPERATING THE MD380 TOOL
1.
After checking to be sure that
the tool is not loaded, point it in a
safe direction and slide the barrel
open. Always hold the front end of
the tool by the heat shield or spall
guard edges.
NEVER
open or close
the tool with your hand over the end
of the muzzle bushing (fastener
loading end of the tool).
2.
With finger off the trigger, and
holding the tool by the heat shield,
place the fastener, point out, into the
muzzle end of the tool until the
point end is inside the muzzle.
NEVER
load a fastener with
your finger on the trigger.
DO
NOT
use excessive force when
inserting a fastener.
STOP
immediately if excessive force is
required, inspect the barrel to
find out why the fastener is not
entering the muzzle freely.
DO
NOT
continue loading unless
the problem is corrected.
3.
While still holding the tool by the
heat shield and with the barrel fully
open, use the ramrod to push the
fastener in the barrel until it is up
against the piston and the piston is
fully set.
Never
ramrod a fastener
into the tool with a live or fired load
in the tool or with the barrel in the
closed position.
RAMROD FASTENER FULLY
INTO THE BARREL
Содержание MD380
Страница 12: ...PARTS SCHEMATIC PARTS SCHEMATIC 12...
