Rampage 45 Sportfish Series, Руководство пользователя

Страница: 117 / 154

CAUTION
Rampage Yachts Inc. will not war-
rant damage incurred due to an
improperly adjusted or neglected
shaft log. Excessive water entry
could result in the submergence
of the engine compartment.
Tighten the shaft log hose clamps using
only hand pressure.
!
RUDDER
BEARING
AND SEAL
CSR173-59
INSPECT PROPELLERS FOR
DAMAGE
1. Check propellers for bends, cracks and
pitting.
2. Do not continue to use badly damaged
propellers. Damaged propellers must be
replaced. See Section 8 for details.
Every 100 Hours
INSPECT FRESHWATER SYSTEM
FOR LEAKS
1. Fill and pressurize freshwater system.
2. Lift port side bunk hatch in aft stateroom.
3. Inspect connections at freshwater reser-
voir, filter, pump and pressure accumula-
tor. There should be no signs of leakage.
If leaks are apparent, drain system and
replace defective hoses, tubes and
clamps. See your Rampage Yachts deal-
er for parts and service.
4. Inspect connections at water heater.
There should be no signs of leakage. If
leaks are apparent, drain system and
replace defective hoses, tubes and
clamps. See your Rampage Yachts deal-
er for parts and service.
CLEAN BILGE
See Section 8, GENERAL MAINTENANCE
for details.
Monthly
LUBRICATE AIR HORN
COMPRESSOR
1. The compressor is located next to the
horn on the starboard side, upper helm
station.
2. Locate the compressor’s oil feed tube.
3. Remove feed tube cover, and add 4 to 7
drops of oil.
CSR164-30A
COVER
FEED TUBE
6-7
45 Sportfish Series
®
Downloaded
from
Cruisers
Owners
Forum
http://www.CruisersOwnersForum.com