96
GETTING TO KNOW YOUR VEHICLE
2. Remove the connector bracket from the sill
by pushing inward in the locking tab.
Locking Tab
3. Disconnect the chassis wiring harness,
ensuring the connector bracket does not
fall into the sill.
4. Connect the chassis plug and bracket
(provided in the glove compartment) to the
chassis wiring harness and insert the
bracket back into the sill.
5. Connect the tailgate plug (provided in the
glove compartment) to the tailgate wiring
harness to ensure that the terminals do not
corrode.
6. Tape the tailgate harness and bracket
against the forward-facing surface of the
tailgate. This will prevent damaging the
connector and bracket when storing or
reinstalling the tailgate.
Removing The Tailgate
1. Disconnect the wiring harness for the rear
camera and or power locks (if equipped).
NOTE:
Refer to “Disconnecting The Rear Camera And
Remote Keyless Entry” in this section.
2. Unlatch the tailgate and remove the support
cables by releasing the lock tang from the
pivot.
NOTE:
Make sure tailgate is supported when removing
support cables.
Locking Tang
3. Position the tailgate on a 45 degree angle.
4. Raise the right side of the tailgate until the
right side pivot clears the hanger bracket.
5. Slide the entire tailgate to the right to free
the left side pivot.
6. Remove the tailgate from the vehicle.
19_DJD2_OM_EN_USC_t.book Page 96