Raise3D Pro2 Plus, Руководство пользователя

Страница: 33 / 42

3D PRINTER MANUAL - RAISE3D PRO2 SERIES
- 32-
www.raise3d.com
Wipe Wall
Enable Wipe Wall will add extra shell(s) around the model during dual-extruder printing. This wall(s)
can help clean the oozing filament from the unused nozzle to reduce the effects of excess material on
the final model.
Wipe Wall Offset refers to the distance between Wipe Wall and the outer shell of the model. If the wall
is positioned too closely, the Wipe Wall may stick onto the model. If the wall is set too far, the wiping
results may be affected.
Wipe Wall Angle refers to the maximum angle for generating the Wipe Wall. If the maximum angle is
set too low, the wall may have a difficult time obeying the shape of the model, especially around curved
surfaces.
Wipe Wall Loop Lines adjust the thickness of Wipe Wall.
Wipe Wall Type changes the shape of Wipe Wall. The difference among the following 3 types are the
distance between Wipe Wall and the model.
Contoured type will generate a Wipe Wall structure with almost the same shape of the outlines of the
model. In some cases, it will be too close to the model which may be difficult to remove especially with
inner structures.
Water Fall will attempt to follow along the horizontal model contour.
Vertical will create a vertical wall at the height of the model. It is ideal for simple structures like tubes or
cubes.
Dual-extrusion with Multiple Filament Types
Printing with multiple material types may limit printing compatibility. The table below lists all the
officially-supported dual-extrusion material combinations currently possible on the Pro2.