RainMaker FLUIDLOGIC, Руководство по установке

Страница: 7 / 36

INSTALLATION INSTRUCTIONS • 6
Insert the male CPC Connector into the cut end
of the Fluid Line. Once seated into position, slide
the Heat Shrink over the end of the connection.
Make sure to slide the Heat Shrink half-way onto
the hexagonal CPC Connector end.
Once the Heat Shrink is properly aligned, heat
the material with a heat gun, being careful not to
over-heat the area.
17
Insert the CPC Connector into the Bladder and
locate it in its final storage location.
18 19
Assure the measurements are correct and cut
the Fluid Line. Keep the remaining section
of Fluid Line for use later in the installation.
(Coaxial Section #13). Insure the cut is clean, and
perpendicular to avoid any leaks, this is very
important.
Take the supplied loose male CPC Connector
and prepare to connect it to the fluid reservoir.
14
Slide the supplied Heat Shrink over the cut end
of the Fluid Line.
15
16