Place the helmet onto the user and test fit the
Flush 360. Power and prime the system and test
to make sure fluid is flowing properly. Adjust the
Flush 360 to the user’s liking.
17
INSTALLATION INSTRUCTIONS • 25
Use the FluidLogic
™
app to adjust to the user’s
specifications. Welcome to the Hydration Nation!
18
Slide the 6mm Hub Line into the Hose Side of the
Flush 360 Legris Connector until the Hose stops.
15
Remove the Flush 360 from the Hub Line by
depressing the Grey Legris. Cut the 6mm Hub Line
with hose cutters and make sure to leave a few extra
inches to assure the user has enough line to move
freely.
Insure the cut is clean, and perpendicular to
avoid any leaks, this is very important.
14
Run the Hub Line through the vehicle and
approximate the length of the Line needed to
reach the user’s helmet.
13
Place the helmet in the seat location and assure
that the line allows for free movement. Move the
helmet to the left, right, up and down. If there is
excess line, remove the line from the Legris by
simply depressing the gray collar and trim to fit.
16
Содержание FLUIDLOGIC
