RME EAGLE User Manual
Rain Master Irrigation Systems
Page 52
Chapter 5 Function and Execution Key Operations
5.7.4 MANUAL System Check/Syringe Cycle
As a convenience for "walk-through" service work and to measure the flow rate of a particular
station, the controller has a system check feature built-in. This feature will run each station, from
the first to the last, for a selectable time interval of 1 to 9 minutes.
EXAMPLE:
Run a System Check for 3 minutes,
Press:
DO NOT PRESS ENTER
If the flow features have been enabled, (using SETUP) then the display will show the current
measured flow rate in Gallons-Per-Minute. If the flow features are not enabled then CHECK will
appear in the display.
EXAMPLE:
To advance one station at a time,
Press:
EXAMPLE:
To stop the System Check,
Press:
The controller will return to the Automatic Mode.
CAUTION:
This mode sequentially runs every station in the controller. For
example if you have a 24 station unit but only use 23 stations,
the
controller
will
still
apply power to Station 24 and while
doing so, will apply power to the Master Valve/Pump terminal.
This may be a problem for a system configured to use the Master Valve output to drive a pump.
During the period that Station 24 is activated, the pump will be pumping against a closed system. If
the system uses a Master Valve, it will be activated during the period that Station 24 is active and
this could cause heating of the Master Valve's solenoid (especially if the valve depends on water
flow to cool it).
Therefore, if all stations are not used, cancel the System Check/Syringe cycle after the last used
station has completed watering.
MANUAL
3
TUE
MANUAL
QUIT
Содержание RME EAGLE
Страница 1: ......
Страница 7: ...RME EAGLE User Manual Rain Master Irrigation Systems Page vi Table of Contents NOTES...
Страница 168: ......
