Bulldog ADV
Chapter 4
Use of the commands
© Raimondi S.p.a.
Via dei Tipografi, 11 - 41122 Modena (Italia)
Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondiutensili.it - e-mail: [email protected]
Use and Maintenance Manual
Page 23/44-4
N
Adjust the two wheels (
N
) and carry on processing the material.
Materials with a width ranging from 45 mm (1
25/32”
) to 70 mm (2
49/64”
)
In order to use this material size, the pressing device (
P
) must be assembled onto side supports. Screws (
Q
) must be loose
in order to ensure its movement. Use properly sized wrenches (
r
) to assemble the pressing device.
r
P
Q
r
Position the material to be shaped onto the trolley perfectly rested against the frame slide (
E
) and against the rear support
(
F
) of trolley. Loosen side knobs (
O
) and extract steel square from below the black square up to its end of stroke and tighten
them. In order to prevent the material from shifting, draw the steel square (
G
) near it and lock it by knobs (
h
).
E
F
O
h
BEFOrE STArTING PrOCES-
SING, MAKE SUrE ThAT ThE
PrESSING DEVICE Or CLAM-
PS (I) DO NOT INTErFErE
WITh TOOLS Or PrOTECTI-
VE DEVICES.
Lock material by means of movable clamps (
I
) onto pressing device (
P
); they can slide on the black square, thus loosening
handles (
L
) and they can be adjusted according to material thickness by means of wing nuts (
M
).
Adjust the two wheels (
N
) and carry on processing the material.
P
I
M
N
