ACG
Track AC out
Accessory Operation from Switch Track AC Out Screw Terminal:
Figure 5:
Multiple switch operation through one Remote Switch (track power,
identical throws):
Figure 7:
Cut Insulation with
wire strippers
Separate Insulation
to reveal bare wire
Wrap around screw
Primary Switch
Secondary Switch
To Remote
Switch
!
Connect the ACG (Common) terminal of the accessory to the ACG
(Common) screw terminal of the Switch.
!
Connect the AC (Powered) terminal of the accessory to the Track AC Out
screw terminal of the Switch.
!
Connect Remote Switch as shown in Figure 2.
!
Connect the STRAIGHT AC screw terminal of the Primary Switch to the
STRAIGHT AC screw terminal of the Secondary Switch.
!
Connect the CURVED AC screw terminal of the Primary Switch to the
CURVED AC screw terminal of the Secondary Switch.
!
Connect the ACG (Common) screw terminal of the Primary Switch to the
ACG (Common) screw terminal of the Secondary Switch.
RealTrax® O-42 Switch Multiple Switch Operation
9
Figure 6:
Making Multiple Connections Under One Screw Terminal
If you do not use female disconnect type connectors to make your wire
terminations for multiple connections, you are encouraged to reduce the
number of wires under each Screw Terminal by stripping a section in the
middle of a single wire (see figure 6, below):
(Note: MTH recommends that 18 gauge or thicker wire be used in wiring the RealTrax switch.)
Содержание RealTrax 0-42
Страница 5: ...5 1 2 3 4 5 Figure 1a...
