STARDOM IDE RAID Solution
12
Chapter 3
How to Use SR3500
3-1 RAID Level Setup
SR3500 can be set for RAID 1 or RAID 0. It is unchangeable when it
has been set, otherwise the data will be damaged. Therefore, before
setting please consider your SR3500 system is going to be used to
ensure the “data security” or “ expand storage capacity”.
The setting up method of RAID level
A switch on the SR3500 rear panel and it is set for default value RAID
1, if you want to change to RAID 0 mode which only need to adjust the
switch to another side.
Factory Default
Ÿ
Operation Mode Switch RAID 1
Setup RAID 1
Ÿ
Installing two new Hard Disks
1.
Install two Removable Carriers with hard disk into the
SR3500.
2.
Use the Disk manager software at the control panel of
the O.S. to make up the partition and formatting
procedure.
5 Install other required software. (Refer to RAIDGuide
Installation)
6. When the two installed hard disks have different
capacities, SR3500 will auto detect and set the capacity
according to the smaller one. This way your computer