Page 20
Version 1.0
The message "Search concluded" will appear onscreen when the clock disap-
pears. However, if either of the messages "Out of search range." or "Search
failed." should appear onscreen, check the settings you have made one after the
other, correct them, and continue correcting them until the search is successful.
•
Press the EXIT-key to exit this menu item.
6.6.7 Checking Signal Strength
You should check the alignment of your satellite antenna on a regular basis if you want to have the best-
possible reception.
•
Use the
and
-keys to highlight the "Signal Strength” field and then press
the MENU-key.
EXIT
Setup Value
Satellite
Installation
1 - 3 - 4
Signal Strength
DiSEqC/22KHz
Auto Search
LNB Lokal-Freq
Manual Search
SNR
[STATUS]
The legend "[STATUS]” will appear onscreen for a few seconds, when it will be
replaced by "[LOCK],” accompanied by a triangular figure. If the latter has only
yellow and red segments, then the received signal strength is weak.
•
Cautiously realign the antenna until the triangular figure reaches maximum size.
You will then have the best-possible reception of the broadcast signal.
If the legend "[UNLOCK]” should appear following "[STATUS],” check the cabling
interconnecting the antenna and the receiver and the parameter settings covered
in the preceding sections.
•
Press the EXIT-key to exit this menu.
6.7
Editing Transponder Data
6.7.1 Procedures for Editing Transponder Data
•
In the main menu, highlight the "Installation" field and confirm your selection
by pressing the MENU-key.
•
Highlight the "Satellite" field and confirm your selection by pressing the
MENU-key.
Programming Your Receiver
EXIT
EXIT
