Version 1.0
Page 15
GB
MENU/EXIT
Setup Value
Satellite
Installation
1 - 3 - 3
Signal Stength
DiSEqC/22KHz
Auto Search
LNB Lokal-Freq
Manual Search
22KHz
A
DiSEqC
AUTO
•
Use the
-key or
-key to switch the "22 kHz" option on or off or to select the
desired DiSEqC-controller and confirm your choice by pressing the MENU-key.
•
In order to be able to receive the largest number of channels, you will have to repeat
the automatic channel-search procedure (cf. Section 6.5.4) for each setting of the
DiSEqC-controller and each status (ON/OFF) of the 22-kHz control signal.
6.5.4 Automatic Channel Search
Once the settings covered under Sections 6.5.1 through 6.5.3, above, have all been made, you may con-
duct an automatic channel search over those downlink frequency bands that have been set.
•
Use the
and
-keys to highlight the "Auto Search” field:
EXIT
Setup Value
Satellite
Installation
1 - 3 - 5
Signal Strength
DiSEqC/22KHz
Auto Search
DF:3734 SR:5.832 3/26 New:5
LNB Lokal-Freq
Manual Search
Search complete
•
Press the MENU-key to start the search.
While the search is in progress, a clock will appear at the lower right-hand corner
of the screen. You will also see a blue bar indicating the extent of the frequency
band that has thus far been searched. The other items appearing onscreen have
the following meanings:
DF: .... -
The satellite down-link frequency involved
SR:.... -
The symbol rate
.../...
-
The ratio of the total number of transponders found to the total
number of transponders available within the preset frequency
band involved
New:... -
The total number of new channels saved to the receiver’s memory
Programming Your Receiver
