RadioMaster Zorro, Инструкция по эксплуатации

Страница: 21 / 39

T-Reverse
：
Throttle reverse
T-Source
：
Throttle operation source (input source), because the throttle trigger timer is
used, such as the THs function, it is usually set to the throttle channel instead of the gimbal,
so that the throttle lever operation triggers the timer correctly
T-Trim-Idle
：
Throttle trim only affects the low position, where trim only affects the idle
part of the throttle travel and does not touch the entire throttle range.
Preflight Checks
：
Pre-flight check, when booting or loading the model, the system will
check the following default settings, if it does not match the following model settings, the
system will pop up a security warning page
Checklist
：
Show checklist
T-Warning
：
Throttle status warning, when the radio control is powered on or the model is
loaded, if the throttle stick is not at the lowest position, a warning will be issued
S-Warning
：
Switch position check, defines whether the radio-control checks whether the
switch is in a predetermined position when the radio control is powered on or when
loading a model. To set them, place all the switches in the way you like, and then press and
hold ENT (the confirmation key), the system will save all current switch positions as default
values
Pot warn
：
Check the position of the knob and slider. The default position of the preset
knob and slider is the same as above.
Ctr Beep
：
Center prompt sound, select whether the gimbal, knob and slider will emit a
prompt sound when reaching the center point.
Glob.Funcs
：
Use global function settings, choose whether to apply global function settings
to the current model
Internal RF
：
Built-in wireless RF module, built-in 4in1 multi-protocol RF module, CC2500
or ELRS module, please refer to multi-protocol RF module manual for usage
External RF
：
External RF module, compatible with many mainstream RF modules
Trainer
：
Trainer Mode
Mode ：
Master/Jack Audio cable connection, coach host mode
Slave/Jack Audio cable connection, student slave mode
Master/Multi
4in1 multi-protocol module coach host mode (This function
needs to add an external 4in1 multi-protocol module as coach
input receiver RX mode)