Radioddity DB25-D, Расширенное руководство, Страница: 77 / 209

Radiod d ity Extended manual for Radiod d ity DB25-D & GD-88 v2.0
© Radiod d ity 2022 page 77 of 209
3. Press the [OK]-key to confirm the factory reset, or press the [Back]-key to
cancel.
Notes : If you restore the factory settings, the radio will be restored with those settings
that have previously been saved using the Radiod d ity CPS as your radios
factory settings. All data will be overwritten by those as saved for the factory
reset procedure. For more details, please check chapter 11.3 FactoryReset on
page 103.
ABRepeat
The Radiod d ity GD-88 comes with two totally independent VFOs. This allows the
radio to also operate as a repeater. Crossband-, cross mode- as well as hybrid-
and even digital-repeating are all possible. In general, there are two channel
definitions required to use the repeating functionality.
1. Press the preset [Relay On /Off]-key to turn the repeater-functionality of the
GD-88 On or Off.
or
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[
▲
/
▼
]-keys to choose Local Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [
▲
/
▼
]-keys to choose ABRepeat and press
the [Select]-key to choose from the following options:
(1) A/B RepeatSw
→
Press the [Select]-key to switch repeater-mode On or Off
for the currently selected channel
→
press the [Back]-key to return to the
previous level
(2) A/B ListenSw
→
Press the [Select]-key to turn monitoring of the currently
selected channel On or Off
→
press the [Back]-key to return to the previous
level. The parameter is only evaluated by the radio firmware if A/B RepeatSw
is turned On.
(3) A RepeatMode
→
Press the [Select]-key to choose for VFO-A from
OFF The currently selected channel is not in repeater-mode.
Tran_Rx The currently selected channel is supposed to be part of a
repeater-setup and RX is only enabled if the channel is in
repeater-mode.
Tran_Tx The currently selected channel is supposed to be part of a
repeater-setup and TX is only enabled if the channel is in
repeater-mode.