Radioddity DB25-D, Расширенное руководство, Страница: 45 / 209

Radiod d ity Extended manual for Radiod d ity DB25-D & GD-88 v2.0
© Radiod d ity 2022 page 45 of 209
3. In standby, press the [TONE/T.SEL]-key, and then choose the required signaling.
This is only possible with the Radiod
d ity DB25-D .
(1) Choose the signaling type : single click the [TONE/T.SEL]-key to choose from
QT , DQT, DQI or none. The signaling icon will display at the upper right of
the current VFOs channel.
(2) Choose the signaling code / frequency : long press the [TONE/T.SEL]-key to
display the current signaling code/frequency at the upper right of current
VFOs channel, rotate the [ENC] button to choose the desired signaling
code/frequency and press the [Menu]-key to confirm your selection. Or
press the [TONE/T.SET]-key to set RX (R:XXXX) or TX (T:XXXX) signaling code/
frequency.
6.8 Channel Selection
The desired working channel can be selected as follows:
1. When the ‘ ’ icon or ‘ CTRL ’ is shown left to the channel name of VFO A or B,
rotate the [ENC] knob or use the [
▲
/
▼
] to select the desired channel.
2. When the ‘ ’ icon or ‘ CTRL ’ is shown left to the channel name of VFO A or B,
input the desired channel number by using the numerical keypad.
3. When ‘ CTRL ’ is shown left to the channel name of VFO A or B. press the [Menu]-
key for 3 seconds. A dialog box and total channels of current zone pops up, to
enter the desired channel number through the numerical keypad.
6.9 Switch between VFO and Channel Mode
In Standby Mode, when the ‘ ’ icon is shown left to the VFO A or B, access
the ‘MENU
→
Local Set
→
DisplayMode’ and choose VFO Mode as Display
Mode.
In Standby Mode, when the ‘ CTRL ’ is shown left to the VFO A or B, long press
the [VFO A/B TX selection]-key to switch the display mode between VFO
Mode and Channel Mode .