24
B
as
ic
O
pe
ra
ti
on
2
B
as
ic
O
pe
ra
tio
n
Scanning the Stored Channels
Press
SCAN/MAN
until
SCAN
appears to continuously
scan through all channels with stored frequencies.
If the scanner finds an active frequency, it stops and
displays that channel and frequency number, then
it automatically begins scanning again when the
transmission on that frequency ends.
n
Notes:
• Press
e
or
d
to reverse the scanning direction.
• Press
•/DELAY
to set the scanner to remain on
the current channel for two seconds after the
transmission ends.
• To set the scanner to remain on the current channel,
even after the transmission stops, press
SCAN/
MAN
at any time during the transmission so
MAN
appears and
SCAN
disappears (see
“Monitoring a
Stored Channel”
below).
• Press
L/O
to lock-out a channel.
Turning Channel-Storage Banks On and Off
To turn a channel-storage bank on or off, press the
bank’s number key (
1–0,
using
0
for bank 10) during
scanning. The channel-storage banks are on when
they have a bar underneath them and off when no bar
appears underneath them.
n
Notes:
• The scanner does not scan any of the channels
within the banks you have turned off.
• You cannot turn off all banks; there must be at least
one active bank.
• You can manually select any channel in a bank, even
if the bank is turned off.
• When you turn on a bank during scanning, the
scanner moves to the selected bank and scans it.
• If no transmission is found, the scanner continues to
scan through all selected banks.
Monitoring a Stored Channel
You can continuously monitor a specific channel without
scanning. This could be useful if you hear a transmission
on a channel and do not want to miss any details, even
though there might be periods of silence.
1.
Press
SCAN/MAN
until
MAN
appears.
2.
Enter the channel number (1–200).
.
Press
SCAN/MAN
again.
Clearing a Stored Channel
To remove a frequency stored in a channel.
1.
Press
SCAN/MAN
to stop scanning.
2.
Press the number keys to enter the channel number
(1–200).
.
Press
PGM.
PGM
appears.
4.
Press
0
then
ENT
. The frequency number changes
to
000.000
0
to indicate the channel is cleared.
.
To clear another channel, use the number keys to
enter that channel number then press
PGM
again.
Or, repeatedly press
PGM
until the desired channel
number appears. Repeat Step 4.
Listening to the Marine Bank
Press
to search the marine bank.
MAr
appears about
two seconds, then the scanner starts searching from
marine channel 16. To change the search direction,
press
e
or
d
.
Press
PSE
to stop searching.
SRCH
disappears and
MAN
appears.
• To change the channel manually, press
e
or
d
.
• To select a channel directly, enter the two-digit
channel number. See
“Marine Service Bank”
on page 6
for a list of channels.
• To lock-out a frequency, press
L/O
.
Press
PSE
again to restart the marine bank search.
