RS-125/230 User Manual
– Revision 1.05
PC CONNECTIONS
Radiation Solutions Inc
– Proprietary
Page 38
Revision Date: December 11, 2015
ASSAY SCAN data at selected SCAN rate (typically 30 secs)
In the above example the left side of the display shows some vertical histogram data with a blue ball
–
this is the
ASSAY
data. To see it use the ZOOM capability and highlight only this section of the data
and zoom it to see a display like below.
This display shows the individual 30 sec data for K, U and Th in a histogram format with the GREEN
line being the Total Count data. The bottom left data block shows the color scheme
–
RED = K
etc.
Position the cursor over any histogram selection and the lower left data block shows the numeric
results. Also the PURPLE line above shows that GPS data was taken so the cursor selection also
shows GPS coordinates.
Once again moving the cursor along the data
permits numeric and GPS data to be seen in the
lower left data box.
SURVEY DATA at selected rate (typically 1/sec) -
If the whole data set is zoomed then the ASSAY data is suppressed and the raw Total Count data
is seen as a graph
– see figure below.
“NORMAL” ASSAY DATA
The data stored by the user with the ASSAY selection (typically
120 secs) is also viewable on these displays. The example below
is such a data set.
The data marked as
“S”
are the individual stored ASSAY results.
Click on any “
S
” to see the data.
D-1009 REV 01.05 Status: RELEASED printed 18/12/2015 5:26:09 PM by Radiation Solutions Inc.
