RS-125/230 User Manual
– Revision 1.05
SYSTEM OPERATION
Radiation Solutions Inc
– Proprietary
Page 4
Revision Date: December 11, 2015
2.4 POWER ON after BATTERY CHANGE
Press the
BUTTON
until the unit beeps then release the
BUTTON
. The battery change label is shown.
The next display requires battery type selection.
NOTE
: The Battery Type selection is required to let the unit know which batteries are used. Battery
discharge rates vary between battery type so that for Low Battery detection it is essential the
unit knows the correct battery selection. Normally RECHARGEABLE batteries are the correct
option for the RS-125 as this is what is supplied with the unit
– but the user can select to suit
their requirements.
CAUTION: USERS SHOULD BE CAREFUL NOT TO LOAD non-RECHARGEABLE BATTERIES
SUCH AS ALKALINE, INTO THE UNIT WHEN CHARGING THEM. EVEN THOUGH
THE UNIT IS PROTECTED AGAINST THIS, EVENTUALLY THE ALKALINE
BATTERIES WILL LEAK AND DAMAGE THE INSTRUMENT.
CLICK the
BUTTON
(short less than 1 second) to move between selections. Once the correct
selection is highlighted hold the
Button
(LONG-CLICK) until the selection background changes
–
release the
Button
for the correct selection.
The next display is the start-up display and shows for 3 seconds
then changes to the
SURVEY
display (see
Section 2.6
below).
NOTE:
The software version will be
5v95
in this case.
2.5 POWER ON normal
Press the
BUTTON
until the unit beeps and the sign on display is
seen, then release the
BUTTON
. After 3 seconds the sign on
display changes to the SURVEY DISPLAY.
NOTE: The Version# is the installed software version of
the unit. In any communication with RSI
regarding system performance, it is very helpful
to specify the
SERIAL #
and the
SOFTWARE
VERSION
to enable better trouble shooting
support.
D-1009 REV 01.05 Status: RELEASED printed 18/12/2015 5:26:09 PM by Radiation Solutions Inc.
