Radiant BH15UT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 61 / 82

SECTION 13: W
IRING
55
SECTION 13: WIRING
Connect to the electrical s u pply u sing a 3 pin pl u g v ia a
locally mo u nted do u ble pole f u sed s w itch ha v ing a
minim u m disconnection of 3 mm on each pole. This
s w itch sho u ld be f u sed to 3 amps. The b u rner is f u sed at
2 amps. There are no control connections in the standard
b
u rner. Control is affected by interr u ption of the main
po w er inlet. See Page 55, Section 13.1 through Page 56,
Section 13.4 for the external w iring details for the single-
b u rner, do u ble linear and m u ltib u rner heater systems.
All w iring m u st comply w ith c u rrent w iring reg u lations and
any local reg u lations w hich may apply. Al w ays s w itch off
the s u pply to the b u rner and disconnect by remo v ing the
pl u g before remo v ing the b u rner side panel.
13.1 Typical External Wirin g Dia g ram (Linear or U-Tube)
13.2 Typical External Wirin g Dia g ram (Double Linear Option 1)
DANGER
Electrical Shock Hazard
Disconnect electric before service.
Heater must be properly grounded.
Failure to follow these instructions can result
in death or electrical shock.
230 V
1 Ø
50 Hz
Burner 1
L
N
Earth
Fan 1
Earth
N
L
Burner 2
Fan 2
Burner 3
Fan 3
Controller or
Thermostat
230 V
1 Ø
50 Hz
Burner 1 Burner 2
L
N
Earth
Earth
N
L
Fan
Controller or
Thermostat