63
EN
Reset the original connection in accordance with the connection diagrams [ 23 to 25 ] on pages 58 to 59
if you have carried out the setting with the universal setting cable.
i
In the event that a malfunction occurs during the setting process, e.g. the tubular motor only runs for a
single rotation even when you press and hold the set button, the adapter
(8)
may have slipped off the
drive head
(6)
.
◆
Check and, if necessary, correct the positioning of the adapter
(8)
, see page 65.
10. Manual adjustment of end points
10.1 Test run / modifying the end points
Test run
1.
Subsequently check the direction of travel, if the
RolloTube S-line Sun DuoFern is being operated
using a switch or button.
Switch the lines for the rotation direction if the
direction of travel is incorrect, see connection dia-
grams
2.
Check the settings and allow the awning to run in
both directions, until the end points switch off the
motor.
Modifying the end points
Move the awning back to the centre position and
begin the process again.
ATTENTION!
The tubular motors are designed for transient
operation (approx. 4 min.).
If this period is exceeded, or if the equipment is
switched over frequently, then the motor may heat
up and the thermal protection system will switch
it off.
◆
In this case, allow the motor to cool down for
20 minutes.
i
The fabric tensioning function is active
during the manual end point setting
after the first run cycle.
