Racepak
Racepak
Racepak
Racepak
949-709-5555
www.Racepak.com
The next step in getting familiar with your new system is to review the various components that make up the
overall data logger system. The drawing on the following page illustrates a typical data logger system using a
Sportsman data logger. We have labeled the various components on the drawing. Each of the components is
described below.
Sportsman Data Logger: Harness and connectors
Connector Rear View
YLW
A
RED
C
BLUE
B
BLK
D
PWR / TACH / REC INPUT
CONNECTOR
A
B
C
D
Yellow Wire
Blue Wire
Red Wire
Black Wire
Record Button input, connect to ground to start recording
Tach Input, 50% Duty Cycle, 12 volt square wave signal
Main Power, connect to +12 volt power source
Main Ground, connect to chassis ground
Connector Rear View
CLR
A
RED
C
ORG
B
BLK
D
DS RPM / 12V EVENT
CONNECTOR
A
B
C
D
Clear Wire
Orange Wire
Red Wire
Black Wire
+12 Volt Event input, connect to +12 volts to mark event
Driveshaft Signal Input, connects to driveshaft sensor
Driv12 power, connects to driveshaft sensor
Driveshaft Ground, connects to driveshaft sensor
Digital Inputs
Main Power/Digital Input Wiring Harness (PWR/TACH/REC INPUT):
The main power/digital input harness is a wiring harness assembly used to provide power and connect the
digital inputs engine rpm, and record button to the data logger. The main power/digital input wiring
harness connects to the digital input connector marked "PWR/TACH/REC " on the Sportsman.
Secondary/Digital Input Wiring Harness (DS RPM/12 VOLT EVENT):
The secondary digital input harness is a wiring harness assembly used to connect the digital inputs
driveshaft rpm, and 12 volt event to the data logger. The secondary/digital input wiring harness connects
to the digital input connector marked "DS RPM/12 VOLT EVENT" on the Sportsman.
5
G
et
tin
g
A
cq
u
a
in
te
d
