Racepak
Racepak
Racepak
Racepak
949-709-5555
www.Racepak.com
3) Next, insert the memory card in the memory card reader. Now click on the button labeled
Clear Data
Files From Memory Card
. The following screen will appear.
4) To delete all of the data files on the memory card click on the
Delete
All Files
button. To delete only some of the data files on the card
first click on the check boxes of the files you want to clear or delete.
Then click on the
Delete Selected Files
button. When finished,
click on the
Exit
button.
Initiating a Recording with the Sportsman data logger
Anytime power is applied to your system the data logger is ready to record data from the various sensors
connected to the system. When the recording process actually begins and how much data is recorded is
determined by how you program the setup features in your data logger. The staff at RacePak will have setup
your data logger to start recording via pushbutton using the blue wire located in the “PWR/TACH/REC INPUT”
harness. If you wish to modify how the data is recorded read the following information.
The start of the recording can be programmed to occur by three different methods. These are;
Start Recording Immediately
In this mode the data logger begins recording immediately after power up and records data until the
maximum record time is reached, or the power is turned off.
Start Recording Manually on Operator Input
In this mode a momentary push button switch is connected to one of the digital inputs on the data
logger. Each time power is applied to the data logger, the logger monitors the input, and will begin
recording only when the switch button is pushed. Once the recording is started, it will continue until
the maximum record time is reached, or the power is turned off.
Start Recording Automatically when threshold is exceeded.
In this mode the logger is programmed to begin recording only after one of the monitored data channels
exceeds a preset threshold. For instance, the logger can be programmed to begin recording any time the
Engine RPM exceeds 3000 rpm. Once the recording is started, it will continue until the maximum
record time is reached, the power is turned off, or the RPM goes below the Stop Record threshold for
more than 30 seconds.
When setting the start record parameters, please keep in mind that it can take up to 5 seconds from the time a
new recording is initiated, and the time data actually begins to be recorded. This time is required for the
Sportsman data logger to initialize a new recording and varies depending on the number of V-Net channels
installed in your system and the number of data files on the SD memory card.
22
O
p
er
a
ti
n
g
t
h
e
S
p
o
rt
sm
a
n
