TEX1000-LCD
5 / 38
User Manual
Rev. 1.1 - 23/06/05
5. Quick guide for installation and use
This chapter contains the necessary information for installing and using the
machine. In the event any aspects are not completely clear, for example when
using the machine for the first time, we recommend you carefully read the entire
description contained in this manual.
5.1 Preparation
Unpack the exciter and before doing any other operation, be sure it has not been
damaged during transport. In particular check that all the connectors are in perfect
condition.
Check that the voltage selected coincide with mains voltage. The protection fuses
can be accessed from the outside on the rear panel (see figures 6.2). Extract the
fuse carrier with a screwdriver to check its integrity or for replacement, if necessary.
The fuses to be used are different and depends from the mains voltage selected:
@115V
@230V
SERVICE FUSE
(chap. 6.2 – positions [32])
(1x) F1T type 5x20 (1x) F1T type 5x20
MAINS FUSE
(chap. 6.2 – positions [18]-
[34])
(2x) F25T type
10x38
(2x) F16T type
10x38
Check that the
TEX1000-LCD
switch is in the "off" position. POWER button is on
the front panel (see figure 6.1) and inhibits “Surge Protection” machine’s card.
Connect the RF output of the exciter to the antenna cable or to a dummy load able to
dissipate the power generated by the
TEX1000-LCD
.
ATTENTION: without load, when machine is working, don’t touch RF output connector
to avoid electrical shocks and burns.
Connect the mains cable to the MAINS connector on rear panel (see figure 6.2).
ATTENTION:
mains connector is a bare terminals, attention that line is not under
voltage when you are connecting it.
ATTENTION:
It is crucial that the mains system be provided with earthing to ensure
both the operators' safety and correct operation of the device.
Connect the audio cables and RDS/SCA of the signal source to the proper connectors
on the back of the exciter, help yourself with figure 6.2.
