TEX1000-LCD
8 / 38
User Manual
Rev. 1.1 - 23/06/05
(Empty Arrow) - The arrow points out the current line, the parameter of which
cannot be modified. This symbol is present in the menus made up of more than
two lines to help scroll the menu.
When turned on, the LCD display shows the predefined screen with the graphic
representation of the instantaneous modulation level and indication of the direct power
supplied:
Menu 1
The bar on right of "Mod" indicate the progress of the modulation in real time; the
hatched bar signals the maximum nominal modulation level of 75 kHz (100%).
To
change the set power leve
l keep the
ENTER
push button pressed until it enters
the
modification mode
.
The screen that is shown in the modification mode is similar to the following:
Menu 2
The bottom line gives the instantaneous reading of the power (997W in this example),
whereas the bar indicates the set level. To increase the level, press the
push
button and to reduce it, press
.
As the set level increases or decreases, the bar
becomes longer or shorter to display the current setting. When the desired level is
reached, press
ENTER
to confirm and exit the predefined menu. Note that the set
value is stored anyway, so if you press
ESC
or let the timeout go by without pressing
a key, the power will remain at the last set level.
The first pressure of a whichever key serves in order to activate the retroillumination
when the display is switched off.
If you press the
ESC
push button while you are in the predefined menu, you will be
shown the following
selection screen
from which you can access all the other menus:
