TEX1000-LCD
10 / 38
User Manual
Rev. 1.1 - 23/06/05
Status 1
Once restored the normal operation conditions, the power supply will come
rehabilitated with the same modalities antecedent the alarm.
If the modulation ran out, under 20 kHz, for a time of about 5 minutes (not modifiable)
the NO AUDIO status comes displayed in the
predefined screen,
but the power
does not comes inhibited:
Status 2
5.4.1 Operation Menu (Fnc)
From this menu the user can enable or disable the exciter
power supply
, set the
deviation display modality and set up the percentage of
Forward (PgD)
or
Reflected
Power Good (PgR)
.
To operate on one of this voices, select the relative line by the
and
buttons,
then press and keep pressed the
ENTER
button until the command doesn’t come
accepted. In this way the Pwr setting will become from On to Off, or viceversa, and
the Mod setting from “x1” to “x10” or viceversa. To modify the Power Good value
percentage is sufficient, after to have selected the "PgD" or "PgR" voice, set up the
value through the
and
buttons, then confirm with
ENTER
.
Menu 4
