![background image](http://html1.mh-extra.com/html/r-v-r-elettronica/telink-snmp1/telink-snmp1_user-manual_3107668010.webp)
6 / 24
User Manual
Rev. 1.0 - 13/03/09
TELINK-SNMP1
5.1.2 Connections
1) Connect the RS232 output of transmitter to the RS232 input of the TELINK-
SNMP1 interface, through the RS232 cable.
Note : If you intend to connect it directly to a PC, it is necessary to use a crossover
RS232 cable (i.e. when you need to program the Main card). This is a basic
prerequisite to ensure equipment correct operation.
2) Connect the ETHERNET output of TELINK-SNMP1 interface to the appropriate
input of your ADSL router or LAN network. If the connecting device is different,
identify an equivalent.
Note : If you intend to connect it directly to a PC, it is necessary to use a crossover
ethernet cable (i.e. when you need to program the SNMP ANTLAN card). This is
a basic prerequisite to ensure equipment correct operation.
3) Connect the network cable to the relevant MAINS VOLTAGE connector on
TELINK-SNMP1 interface.
5.2 First Power-On and Set-Up
Perform this procedure upon fi rst power-up and each time you make changes to
the confi guration this component is integrated into.
5.2.1 Web User Interface (WUI)
Once all connections previously described are performed, the equipment is ready
for commissioning.
The WUI (Web User Interface) allows you to adjust, modify or display the
confi guration variables such as IP, netmask and gateway address. Follow the
procedure below to open the WUI:
1) Open your web browser on your PC, and connect to http://192.168.0.167
address to connect to the WUI (if LAN IP address was previously modifi ed, it
is necessary to use the new one). At this point the following page opens.
By factory the RVR uses the following adjustments:
•
IP address:
192.168.0.167
•
Netmask address: 255.255.255.0
• Gateway
address:
192.168.0.1