16
/ 40
User Manual
Rev. 2.0 - 29/11/22
SCM6/1
ELETTRONICA
The alarm codes that are handled by the SCM6/1 are the following:
SCM6 Restart
Restart of the SCM
Transmitter Fault
Validated power good fault (-> a changeover is started)
Load Fault
Fault on the dummy load
Sw.Coax Fault
During a changeover, the switch didn’t confirm reaching the
required position
No I2C Comunic
No I2C communication with a transmitter control board
Fault +24V TX
AInterlockence of the power supply of the TC of a TX
Fault OFF TX
The power from a transmitter that was switched off (for
example to perform a manual changeover) has not been cut
No TXR Config Ack
AInterlockence of the acknowledge of the configuration from
the reserve transmitter
5.3.7 GSet menu
The General Settings menu is used to set the date and time of the SCM6/1, that
is used only for diagnostic purpouses (see Alarm menu).
To set the current date and time, enter in the menu screen pushing the encoder
on the indication GSet in the navigation bar. Then rotate the encoder to highlight
the parameter that you want to change and push the encoder again. Rotate the
encoder to show the value to be set and than push the encoder to store the value.
You can than use the encoder to change another parameter or to exit from the menu.
The third and fourth lines give respectively the release number and date of the
management software and the configuration of the jumpers on the panel board.
5.4 The Synoptic
In the front panel of the SCM6/1 there is a synoptic diagram that indicates at once
the status of the controlled transmission system using a set of leds.
Содержание SCM6/1
Страница 1: ...SCM6 1 SCM6 1 USER MANUAL VOLUME1 Manufactured by R V R ELETTRONICA Italy ...
Страница 4: ...ii User Manual Rev 2 0 28 10 22 SCM6 1 ELETTRONICA ...
Страница 6: ...iv User Manual Rev 2 0 28 10 22 SCM6 1 ELETTRONICA This page was intentionally left blank ...
Страница 46: ...40 40 User Manual Rev 2 0 29 11 22 SCM6 1 ELETTRONICA This page was intentionally left blank ...