SCM6/1
ELETTRONICA
13
/ 40
User Manual
Rev. 2.0 - 29/11/22
Name
Name assigned to the transmitter.
To enable the configuration of the transmitters, the SCM6/1 has to be set in
Maintenance or in Configuration mode (see below the Mode menù).
With the encoder, select the line of the transmitter to be configured and push the
encoder. The order number of the transmitter is suInterlocktituted by the icon ,
signalling that the configuration of the transmitter is in progress.
At this point, rotating the encoder will select the different parameters, that can then
be changed pushing the encoder.
To change the name assigned to the transmitter, select it with the encoder and
push it. The name can be changed letter by letter rotating the encoder to select
the desired character, and each time the encoder is pushed the editing passes to
the following letter. When finished with the editing of the name, push the encoder
and keep it pressed until a long beep signals that the new name has been stored
in memory.
The line related to the reserve transmitter is analogous to the ones of the main
transmitters, with the following differences:
• No priority is present
• The position of the switch is not settable manually (in fact, there is no switch
dedicated to the reserve transmitter, and the indication is the consequence of
the positions of the main transmitters switches)
• The status Enabled/Disabled is not settable
• The “Name” shown reflects the status of the of the reserve transmitter: if it
signals to the SCM6/1 that it is configured for frequency “i”, than the name
of transmitter “i” will be shown. If the reserve transmitter doesn’t signal any
configuration, no name will be shown.
• When the SCM6/1 is in local mode and the reserve transmitter is on load, it
is possible to configure it for one of the different transmitter frequencies. With
the encoder, highlight the “Name” field and push it. Rotating the encoder the
different names will be selected in turn. Once the desired name is shown, push
the encoder to send the configured telecontrol to the transmitter. To exit from
this frequency-selection mode, keep the encoder pushed until you hear a long
beep.
5.3.2 Mode Menu
When the SCM6/1 is in local mode, this menu allows the user to select one out
of three operating modes:
EXPLOITATION
The user can only read the parameters without changing them.
Содержание SCM6/1
Страница 1: ...SCM6 1 SCM6 1 USER MANUAL VOLUME1 Manufactured by R V R ELETTRONICA Italy ...
Страница 4: ...ii User Manual Rev 2 0 28 10 22 SCM6 1 ELETTRONICA ...
Страница 6: ...iv User Manual Rev 2 0 28 10 22 SCM6 1 ELETTRONICA This page was intentionally left blank ...
Страница 46: ...40 40 User Manual Rev 2 0 29 11 22 SCM6 1 ELETTRONICA This page was intentionally left blank ...